Were you aware that you could get something as cheap and easy to install as a rubber blanket for your pipes in order to take care of that banging noise you hear in your house? Use this article for this and more great plumbing tips to help you today!
On very cold winter nights, allow your faucets to trickle slightly, especially if your pipes are located in a crawlspace. The running water prevents the pipes from freezing as quickly as they would otherwise. You can catch the water and use it for other household needs to prevent wasting it.
Use your garbage disposal with the cold water running so that you can preserve the blades of the disposal. Using hot water makes grease more liquid and can cause problems, including clogs. Make sure to clean blades by putting in a little dish detergent and run cold water at the same time.
If you have a clogged drain, don’t use cleaning chemicals to try to clear the clog. These harsh chemicals can corrode your metal pipes leading to leaks and broken pipes over time. Instead, stick to a plunger or make use of a plumbing snake to clear them.
Check your faucets for leaks. Check the knobs and the faucet itself. Hundreds of gallons of water a day can be wasted due to leaks and that’s not good if you’re paying your water bill. By stopping a leak now, you can save yourself a lot of money. Leaks can grow over time as well, so avoid a disaster and check all faucets for leaks!
If your water is coming out black, then most likely you have an iron and magnesium issue to your water. You need to contact a water softener company, and get them to come out and assess your water. They will be able to fix the problem by adding a water softener.
If your home operates on well water and you notice pink or orange stains in your bathtub and other fixtures, this is no doubt due to iron in the water. This is fixed by using water softener, which can be bought at a store, or you can have someone come to your home and fix it.
Always have cold water running when you are using your garbage disposal. The blades will stay sharper, and the overall disposal process will run smoother. Don’t use hot water while running the garbage disposal. Hot water converts the grease in your trash to liquid form. When the liquified grease goes down the drain, it clogs the pipes.
If water backs up from one sink to another, it is because the lines are connected. The part of the branch line for one device might be higher than another, but most likely there is also a blockage in the branch line connecting the two devices as well. This blockage must be cleaned.
To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater’s instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.
To avoid freezing pipes in the winter, make sure to insulate any exposed pipes in you basement before winter comes. Pay extra attention to pipes near the outside walls. If you have had a problem with any particular pipe freezing in the past, apply some heat tape to insulate those pipes.
If you are trying to get a clean-out plug removed, but not getting very far, there are a couple of things you can do. You can loosen the fitting around the plug using a hammer and chisel. The only other alternative is to chisel through the plug.
Make sure that any exposed pipes in your home are insulated, especially those found in crawl spaces on the outside walls of your home. This will help keep them from freezing and causing you tons of problems. Frozen pipes can often be devastating and leave you with problems that are expensive to fix and no water in the middle of winter.
Work with plumbers that offer flat rates. When a plumber is charging by the hour, they do not have an incentive to get the job done quickly. It is human nature to go just a little bit slower if it’ll mean extra money in our pockets. If you cannot find someone who charges per project make sure that you are vigilant in watching the clock and their work.
When plunging a drain to attempt to remove a blockage, first make sure that the drain is completely covered in water. This helps to form a seal. Then, plunge at least fifteen to twenty times before stopping. Repeat the process two to three times. If this doesn’t work, try a chemical drain cleaner.
You should contact your local Consumer Affairs Department before you hire any plumber. You can look at their track record, looking to see whether their license is valid and if they have any complaints lodged against them. If a plumber does not have a current license and even a limited number of complaints, you probably don’t want them working on your home.
Make sure that the temperature of your home’s water heater is not above 120F. On older water heaters, be sure it is not above medium settings. When temperatures get higher than 120, scalding can occur. Also, having the settings above 120F, tends to use more energy than lower temperatures do.
If you install a new water heater, and you start to have a leak from the pressure relief valve, you may need an expansion tank installed. The pressure increases when the functioning of the water heater is being performed properly. Therefore, with your new water heater, it may be necessary to have an expansion tank as well.
In conclusion, there is a lot that you can easily do in your own home when it comes to dealing with plumbing issues. Hopefully you learned a few things and will be able to act on them. Use this advice today and be confident in all of the plumbing work that you do.