Helpful Plumbing Tips From The Pro’s Who Know

When it comes to plumbing, you want to make sure that you are getting the best advice available. Use the tips and tricks provided in this article to ensure that you are getting reliable information to use at home and it will not lead to further, unwanted costs down the road.

Do not try to sell a product that you do not agree with. This includes paying attention to the company itself and their values and policies. If you have any qualms about the company, your customers will pick up on it. You want to be a full supporter of the product you are selling

Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.

To winterize a house that will sit unused during the winter months, you must completely drain all of the pipes. After turning off the main water supply, let all of the water drain from the faucets, toilets, and water heater (turn off the gas). Add a quart of antifreeze to sinks and the tub to prevent water from freezing in the drain trap.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Find out the plumbing codes in your local area before starting any project. Plumbing codes can vary wildly from area to area and you don’t want to run afoul of the codes. Visit your local building department to find out information or hire a plumber for a day to help you go over your plans and provide advice.

Regular maintenance of your plumbing lines is a great idea. Your options are getting your lines snaked or jetted. Jetted is a technology that is proven more effective than snaking is. It gets deeper and cleans harder. So jetting is a good idea next time you are having maintenance performed on your lines.

To protect your money from unsavory plumbers, always get a written estimate before paying a cent or committing to a project. Good businessmen know to under-promise and over-deliver to savvy customers. Once a stated number is given, it is highly unlikely that your plumber will exceed the projected costs of the project.

Using a snake tool to remove blockages is very easy. Just insert the tool a few inches into the drain, and then turn the handle to change the direction of the snake head and search for blockages. Continue moving down slowly and searching until you find the cause of your blockage.

Make sure your plumbing contractor has the proper insurance before letting them work in your home. This is a big problem with all types of construction contractors. They may have the proper licenses, but because of the high cost of insurance, they may not be properly insured and can end up on your homeowners policy if they get hurt.

When leaving on vacation or leaving your vacation home, be sure to turn off the main water before you leave. If something happens while you are gone you can cause some serious damage from a flooded basement or a broken pipe in the wall that leaks for weeks until you return.

Insulate your pipes properly. If the temperature drops below fifty five degrees, your pipes could freeze. This makes pipes extremely fragile and increases the risk of leaks and damages. The pipes inside your house should not freeze but take a look at a plan of your plumbing system to see if you have any pipes outside of your house.

Governmental regulations sometimes prevent plumbers from actively providing maintenance to copper piping. If you have a calcium buildup in your copper piping, you are going to need to take care of this yourself. You have to get rid of all the water and add vinegar which eats away the calcium buildup out of copper pipes.

Hair can clog your drains if you do not clean them regularly. You could also get some screens to place over your drains to keep most of the hair from going down. Hair usually breaks down, but it can cause your drains to back up if they are present in large quantity.

If you think you understand what is wrong with your toilet, but aren’t sure, you should first do some more research on the internet. Most plumbing problems are fairly standard, and you should be able to read about the problem in great detail on several amateur plumber forums to make sure you understand the problem.

To avoid water damage to walls in the kitchen, make sure all seams in your counter tops and back splash are properly sealed using a waterproof silicone. Silicone will dry out over time, crack and shrink and should be replaced once every three years. Keeping your silicone in good shape will keep kitchen spills where they belong and not running down the walls.

In conclusion, it is important that you back yourself up with a great base knowledge of plumbing. Ideally, you were able to find this article both informative and interesting. Use this great information and you will find that you will save a lot of money, as opposed to having to hire a professional.